Gathering data for deploying StorageGRID Webscale appliance

As you plan to deploy the StorageGRID Webscale appliance, you must gather information about Ethernet switch ports and IP addresses. You can use this worksheet to collect the information from your administrator.

About this task

Deployment information	Your values
1-GbE RJ-45 management network ports	Specify the switch port on the management network that each controller will connect to.
	E2700 controller:
	E5600SG controller:
MAC address or management network IP address	If the management networks include DHCP servers, enter the MAC address from the label on the back of each controller. The network administrator can use the MAC address to determine what IP address was assigned by the DHCP server. (For some E5600SG controllers, the DHCP-assigned IP address is displayed on the seven-segment display after you apply power.) If you do not use DHCP, enter the static IP address that you plan to use for these ports on your network.
	E2700 controller:
	E5600SG controller:
Grid network interface ports for the E5600SG controller	Specify the switch ports on the grid network that you will connect to the following 10-GbE optical ports on theE5600SG controller.
	Port 2:
	Port 4:
10-GbE network IP address	Specify the IP address of the grid network interface. Note: This information might not be available at the time you are performing the hardware phase of the installation.
10-GbE network IP address	IP address:
Optional client network interface ports for the E5600SG controller	If you will use a client network, specify the switch ports that you will connect to the following 10-GbE optical ports on the E5600SG controller.
	Port 1:
	Port 3: