Table of ContentsView in Frames

Commands for managing SVM disaster recovery relationships

You can use snapmirror commands to manage SVM disaster recovery relationships. You can specify the source and the destination SVMs as either paths or SVM names. If you want to specify the source and destination SVMs as paths, then the SVM name must be followed by a colon.

You can use the wildcard "*:" to perform an operation on all the SVM disaster recovery relationships in a cluster.

Important: You cannot perform volume-level SnapMirror operations when a disaster recovery relationship is configured for the SVM.
If you want to... Use this command...
Abort an active SnapMirror transfer snapmirror abort

You must run this command on the destination cluster.

Quiesce scheduled SnapMirror transfers snapmirror quiesce
Enable scheduled SnapMirror transfers snapmirror resume
Provide read/write data access from the destination SVM snapmirror break
Delete the SVM disaster recovery relationship snapmirror delete

If you delete and re-create the SnapMirror relationship when it is in the Snapmirrored state, the subsequent updates fail. You must resynchronize the relationship before updating it.

Perform an incremental SnapMirror transfer snapmirror update
Start a resynchronization operation snapmirror resync
Unlock and manage the source SVM after a cluster reboot vserver unlock -force