Table of ContentsView in Frames

Commands for managing mirrored aggregates

There are specific Data ONTAP commands for managing mirrored aggregates.

If you want to... Use this command...
Create a mirrored aggregate storage aggregate create with the -mirror parameter

You cannot use the -disklist or -mirror-disklist parameters when using the -mirror parameter.

Convert an aggregate to a mirrored aggregate storage aggregate mirror
Display status about a plex storage aggregate plex show
Add disks to an aggregate storage aggregate add-disks
Show resync status information for each plex storage aggregate show-resync-status
Correct differences between plexes storage aggregate verify with the -action start and -plex-to-fix parameters
Display the status of a plex comparison storage aggregate verify with the -action status parameter
Start comparing plexes of a mirrored aggregate storage aggregate verify with the -action start parameter

If any discrepancies are found, they appear in the EMS log with the following signature: raid.mirror.verify.mismatch. If no such entries exist, no discrepancies were found.

Stop comparing plexes storage aggregate verify with the -action stop parameter
Resume comparing plexes storage aggregate verify with the -action resume parameter
Temporarily suspend comparing plexes storage aggregate verify with the -action suspend parameter
Bring a plex online storage aggregate plex online
Take a plex offline storage aggregate plex offline
Remove one of the plexes storage aggregate plex delete