Table of ContentsView in Frames

Setting the shelf ID with the ODP push button

You can set or change the shelf ID for a controller shelf or a drive shelf by using the ODP push button.

Before you begin

You might need to remove the front bezel or the end cap to see the ODP push button. The controller shelf or drive shelf must be powered on before you begin this task.

About this task

The following figure shows the ODP push button on the E2812 controller shelf and the DE212C drive shelf.



The following figure shows the ODP push button on the E2824 and E5724 controller shelf and the DE224C drive shelf.



The following figure shows the ODP push button on the E2860 and E5760 controller shelf and the DE460C drive shelf.



1 ODP push button

Steps

  1. Press and hold the push button until the first number on the seven-segment display starts to blink.
    It might take up to three seconds for the number to blink. If the number does not blink in this time, release the button and press it again. Make sure to press the button all the way in.
  2. Change the first number of the shelf ID by repeatedly pressing the push button to advance the number until you reach the desired number from 0 to 9.
    The first number continues to blink.
  3. Press and hold the button until the second number on the digital display starts to blink.
    It might take up to three seconds for the second number to blink. The first number on the seven-segment display stops blinking.
  4. Change the second number of the shelf ID by repeatedly pressing the button to advance the number until you reach the desired number from 0 to 9.
    The second number continues to blink.
  5. Lock in the desired number, and exit the programming mode by pressing and holding the button until the second number stops blinking.
    It might take up to three seconds for the second number to stop blinking.