Table of ContentsView in Frames

Editing protection relationships from the Health/Volume details page

You can edit existing protection relationships to change the current maximum transfer rate, protection policy, or protection schedule. You might edit a relationship to decrease the bandwidth used for transfers, or to increase the frequency of scheduled transfers because data is changing often.

Before you begin

  • You must have the OnCommand Administrator or Storage Administrator role.
  • You must have installed and configured Workflow Automation.

About this task

The selected volumes must be protection relationship destinations. You cannot edit relationships when source volumes, load-sharing volumes, or volumes that are not the destination of a SnapMirror or SnapVault relationship are selected.

Steps

  1. From the Protection tab of the Health/Volume details page, locate in the topology the protection relationship you want to edit and right-click it.
  2. Select Edit from the menu.
    Alternatively, from the Actions menu, select Relationship > Edit to edit the relationship for which you are currently viewing the details.
    The Edit Relationship dialog box is displayed.
  3. In the Edit Relationship dialog box, edit the maximum transfer rate, protection policy, or protection schedule, as needed.
  4. Click Apply.
    The changes are applied to the selected relationships.