Table of ContentsView in Frames

Adding IP addresses to IP-based target portal groups

You can use the iscsi ip_tpgroup add command to add an IP address to an existing IP-based target portal group.

Before you begin

Step

  1. Enter the following command:
    vfiler run vFiler_unit iscsi ip_tpgroup add [-f] tpgroup_name IP_address ...

    -f forces the new group to be created, even if that terminates an existing session using one of the IP addresses being added to the group.

    tpgroup_name is the target portal group name.

    IP_address is the list of IP addresses to include in the group, separated by spaces.

Example

vfiler run vfiler2 iscsi ip_tpgroup add vfiler2_tpg1 192.168.2.1 192.112.2.1