Table of ContentsView in Frames

Starting the NFS protocol

To start the NFS protocol on the vFiler unit, you should use the nfs on command.

Step

  1. To start the NFS protocol, perform the appropriate action based on your role:
    If you are... Then...
    A vfiler0 administrator
    • From the hosting storage system, enter the following command:
      vfiler run vfiler_name nfs on
      Note: When you use an IPv6 address, you must enter the following command:
      vfiler run vfiler_name options nfs.ipv6.enable on
    Any other vFiler unit administrator From the vFiler unit, enter the following command:
    nfs on

Result

The NFS protocol server starts running on the vFiler unit.