Table of ContentsView in Frames

Enabling or disabling SNMP traps for Data ONTAP and the RLM

You can enable or disable SNMP traps for both Data ONTAP and the RLM by using the snmp.enable option.

About this task

The snmp.enable option is the master control for enabling or disabling SNMP traps for both Data ONTAP and the RLM. Consider leaving the snmp.enable option set to on to enable SNMP traps for both Data ONTAP and the RLM.

Step

  1. Enter the following command to enable or disable SNMP traps for both Data ONTAP and the RLM:
    options snmp.enable [on|off]

    The default option is on.

    Note: If you enable SNMP traps on the storage system and the currently installed RLM firmware version does not support SNMP, an EMS message is logged requesting an upgrade of the RLM firmware. Until the firmware upgrade is performed, SNMP traps are not supported on the RLM. For instructions about how to download and update the RLM firmware, see the Data ONTAP Upgrade and Revert/Downgrade Guide for 7-Mode.