Table of ContentsView in Frames

Rebooting the storage system remotely

You can reboot the storage system remotely by using the remote management device.

Steps

  1. From the administration host, log in to the remote management device by entering the following command:
    ssh username@IP_for_remote_management_device

    One of the following remote management device CLI prompts appears, depending on the platform model:

    SP>
    RLM>

  2. To power on the storage system, enter the following command at the CLI prompt for the remote management device:
    system power on
  3. To access the system console, enter the following command at the CLI prompt for the remote management device:
    system console
  4. If the storage system does not reboot automatically, enter one of the following commands at the boot environment prompt:
    To use the... Enter...
    Current release of Data ONTAP
    boot_ontap
    Data ONTAP primary image from the boot device
    boot_primary
    Data ONTAP backup image from the boot device
    boot_backup