Table of ContentsView in Frames

Setting the privilege level

You set the privilege level to access commands at either the administrative or the advanced level.

Step

  1. Enter the following command:
    priv set [-q] [admin | advanced]

    admin sets the privilege level to administrative.

    advanced sets the privilege level to advanced.

    -q enables quiet mode. It suppresses the warning that normally appears when you set the privilege level to advanced.

    Note: If no argument is given, the default, admin, is applied.

    Example

    Assuming the name of the storage system is sys1, the storage system prompt is sys1>, as shown in the following example.

    sys1> priv set advanced

    The following message is displayed, followed by the advanced mode storage system prompt.

    Warning: These advanced commands are potentially dangerous; use them only when directed to do so by technical personnel.
    sys1*>