Table of ContentsView in Frames

Using the e0M interface to perform a Data ONTAP management task

You can use the e0M interface to access the storage system to manage Data ONTAP.


  1. Open a session on a client by using a management protocol such as SSH.

    For information about how to use the e0M interface with SNMP, see the Data ONTAP Network Management Guide for 7-Mode.

  2. Connect to the storage system by using the IP address of the e0M interface.
  3. Log in to the storage system with an appropriate user name and a valid password.
  4. At the storage system prompt, enter a Data ONTAP CLI command.