Manual Pages
Table of Contents
na_download - Sets a newly-installed version of Data ONTAP
as the default boot image for subsequent reboots.
download [ -d ]
This command is deprecated. Use software update instead.
If a version of Data ONTAP was previously installed using
the software command, the download command sets that version
as the default boot image during the next clean shutdown.
After the node reboots, the version of the newly-installed
software can be verified with the version command.
The download command only applies to the node on which the
command is entered. The download command is explicitly
not allowed in takeover mode.
When using the download command on an HA system, the command
must be entered on each node so that all nodes will
boot with the same version of Data ONTAP.
- -d
- This option is available at the "advanced"
privilege level and may be used to install
a service image package. Depending on system
load, the operation may take several
minutes to finish. If executing the command
from the console, the console will be
unavailable until the command finishes.
The download operation may be cancelled
with Ctrl-C in the first 6 seconds.
na_software(1), na_version(1), na_partner(1), na_boot(5).
Table of Contents