Table of ContentsView in Frames

Configuring the FlexCache Autogrow capability

With the Autogrow capability enabled, Data ONTAP increases the size of a FlexCache volume when the volume starts to fill up. The Autogrow capability is enabled and disabled per FlexCache volume, and is enabled by default on new FlexCache volumes.

Step

  1. Enter the command below, depending on the operation you want to perform:
    If you want to.. Then enter...
    Enable the Autogrow capability vol options vol_name flexcache_autogrow on
    Disable the Autogrow capability vol options vol_name flexcache_autogrow off

Example

To enable the FlexCache Autogrow capability on the FlexCache volume fc1, enter the following command:vol options fc1 flexcache_autogrow on