Table of ContentsView in Frames

Planning primary and secondary qtree locations

Planning the location of primary system qtrees or open systems directories and their corresponding secondary system qtrees is helpful for better storage management. You can back up multiple qtrees from different volumes and multiple open systems directories to corresponding qtrees in a single volume.

Step

  1. List the primary system qtrees or open systems directories and their corresponding secondary system qtrees in a table. For an example, see the following table.

    Primary system qtree or directory location Corresponding secondary system qtree location
    systemA:/vol/vol1/qtreeAA sv_secondary:/vol/sv_vol/qtreeAA
    systemA:/vol/vol1/qtreeAB sv_secondary:/vol/sv_vol/qtreeAB
    systemB:/vol/vol1/qtreeBB sv_secondary:/vol/sv_vol/qtreeBB
    winsrvrA:c:\melzdir sv_secondary:/vol/sv_vol/melzdir
    ux_srvrB:/usrs/moz_acct sv_secondary:/vol/sv_vol/moz_acct
    Note: The maximum number of secondary system qtrees per volume is 255. SnapVault backup of qtrees over a Fibre Channel network is not supported.