Use the t or T option in the restore command to specify a table-of-contents restore.
Step
- To specify a table-of-contents restore, use the T or t option in the restore command line, with files as parameter.
If there is no parameter, the entire content of a backup is listed.
Example
The following command lists all files in a backup:
restore tf rst0a
The following list describes the elements of this command line:
- t
- Lists all the files.
Note: Option T lists all qtree names.
- f
- Specifies that a tape device is supplied in the command line.
- rst0a
- The tape device.