Table of ContentsView in Frames

Obtaining fabric zone server data

You can use the zone server to access zone membership as well as port information. The fcp zone show command enables you to view the active zone set on the fabric connected to the target port and to verify the zoning information on the fabric zone server.

About this task

Note: You should understand that not all FC switch vendors support the necessary fabric commands that are used to obtain zoning information.

Step

  1. Obtain the fabric zone server data by entering the following command:
    fcp zone show

Example: Fabric zone server data

system1> fcp zone show 4a
Active Zone Set on adapter 4a:
Zone Set Name: sanset (1 zones)
Zone Name: testzone
	Member Port Name: 10:00:00:00:c9:2d:60:dc
        Member Port Name: 50:0a:09:82:87:09:2b:7d
        Member Port ID: 0x650003
        Member Fabric Port Name: 20:07:00:0d:ec:00:22:80