Table of ContentsView in Frames

Enabling the iSCSI license

Before you can use the iSCSI target service, you must enable the iSCSI license by entering the iSCSI license key and turning on the iscsi option.

Steps

  1. Use the following command to enter your license key:
    license add iscsi_license_code

    Example

    system1> license add XXXXXXXXXXXXXXXXXXXXXXXXXXXX
    license add: successfully added license key " XXXXXXXXXXXXXXXXXXXXXXXXXXXX".
    

  2. Enter the following command to enable the iscsi option:
    options licensed_feature.iscsi.enable on

    Example

    system1> options licensed_feature.iscsi.enable on
    Tue Sep 11 05:24:44 GMT [f3170-SAN-235-12:kern.cli.cmd:debug]: Command line input: the command is 'options'. 
    The full command line is 'options licensed_feature.iscsi.enable on'.
    Run 'iscsi start' to start the iSCSI service.
    Also run 'lun setup' if necessary to configure LUNs.