You can use the fcp config command to display information about target adapters in the system, as well as to quickly detect whether the adapters are active and online.
About this task
The output of the fcp config command depends on the storage system model.
Step
- Enter the following command:
fcp config Example
The fcp config command displays the following output:
7a: ONLINE [ADAPTER UP] PTP Fabric
host address 170900
portname 50:0a:09:83:86:87:a5:09
nodename 50:0a:09:80:86:87:a5:09
mediatype ptp partner adapter 7a
7b: ONLINE [ADAPTER UP] PTP Fabric
host address 171800
portname 50:0a:09:8c:86:57:11:22
nodename 50:0a:09:80:86:57:11:22
mediatype ptp partner adapter 7b
Example
The following example shows output for the 30xx. The fcp config command displays information about the onboard ports connected to the SAN:
0c: ONLINE [ADAPTER UP] PTP Fabric
host address 010900
portname 50:0a:09:81:86:f7:a8:42
nodename 50:0a:09:80:86:f7:a8:42
mediatype ptp partner adapter 0d
0d: ONLINE [ADAPTER UP] PTP Fabric
host address 010800
portname 50:0a:09:8a:86:47:a8:32
nodename 50:0a:09:80:86:47:a8:32
mediatype ptp partner adapter 0c