- Updates for FAS920
- Update for NVRAM5
- Illustration updates
|
Data ONTAP 6.5.1 |
May 2004 |
- Updates for NVRAM5 support in FAS900 series HA pairs, except for MetroCluster.
- Failover event cause-and-effect table.
- Declaration of Conformity update.
- Addition of controller failover and single-point-of-failure analysis.
|
Data ONTAP 7.0 |
November 2004 |
- FAS30xx information.
- Corrections were made to the Upgrading an LRC to ESH/ESH2/AT-FCX procedure.
|
Data ONTAP 7.0.1 |
April 2005 |
- Incorporation of the Cluster Administration chapter from the Data ONTAP
7-Mode
System Administration Guide and the Disaster Protection Using MetroCluster appendix from the Data ONTAP Data Protection Online Backup and Recovery Guide.
|
Data ONTAP 7.1 |
June 2005 |
- Updated MetroCluster information for FAS30xx
|
Data ONTAP 7.1 |
October 2005 |
- Updated module replacement information.
- Fixed problem in Brocade switch configuration information.
|
Data ONTAP 7.1 |
December 2005 |
- Updated and extended HA pair information.
- Moved Brocade switch configuration to Brocade Switch Description Page.
- Moved from cluster to active/active configuration.
- Added information about Multipath Storage for HA pairs.
|
Data ONTAP 7.1.1 |
June 2006 |
- Generalized standard and mirrored HA pair cabling instructions.
- Updated standard and mirrored HA pair cabling instructions to include FAS60xx.
|
Data ONTAP 7.2 RC1 |
February 2006 |
- Changed name of document from Cluster Installation and Administration Guide to Active/Active Configuration Guide.
- Added FAS60xx information
- Updated and extended HA pairs configuration information.
- Moved Brocade switch configuration to Brocade Switch Description Page.
- Moved from cluster to active/active configuration.
|
Data ONTAP 7.2 RC3 |
May 2006 |
- Added information about Multipath Storage for HA pairs.
|
Data ONTAP 7.2.1 |
November 2006 |
- Added quad-port, 4-Gb Fibre Channel HBA, ESH4 module, DS14mk4 FC disk shelf information.
- Added information to explain that automatic giveback should not be used in MetroClusters.
- Updated Multipath Storage information.
- Updated MetroCluster disaster recovery information.
- Corrected failover and single-point-of-failure table.
|
Data ONTAP 7.2.2 |
March 2007 |
- Added procedures for configuring fabric-attached MetroClusters on systems using software-based disk management.
- Added procedure for unconfiguring an active/active pair and returning to stand-alone operation.
|
Data ONTAP 7.2.3 |
June 2007 |
- Added support for 504 disks in MetroClusters.
- Added support for the FAS6040 and FAS6080 systems.
- Added support for the change_fsid option.
- Added procedure for removing an HA pair.
|
Data ONTAP 7.2.4 |
November 2007 |
- Changed name of document from Active/Active Configuration Guide to High-Availability Configuration Guide.
- Moved from active/active configuration to High Availability pair.
- Added information about configuration on V-Series systems.
- Added support for 672 disks in MetroClusters.
- Added MetroCluster support for the Brocade 300 and 5100 switches.
|
Data ONTAP 8.0 RC1 |
June 2009 |
- Added references to the DS4243 disk shelf documentation.
|
Data ONTAP 8.0 GA |
January 2010 |
- Added support for 32xx and 62xx systems.
- Added support for the 8-Gbps FC-VI adapter on MetroCluster configurations.
|
Data ONTAP 8.0.1 |
August 2010 |
- Added support for 32xx and 62xx systems.
- Added support for the 8-Gbps FC-VI adapter on MetroCluster configurations.
|
Data ONTAP 7.3.5 |
October 2010 |
- Added more SAS disk shelf information and references to SAS disk shelf documentation.
- Updated multipath HA as a requirement.
- Removed procedures for non-multipath HA cabling.
- Replaced the term Multipath Storage with multipath HA for consistency with other documentation.
|
Data ONTAP 8.0.2 Data ONTAP 7.3.5.1
|
May 2011 |
- Added support for MetroCluster with SAS disk shelves.
- Added support for MetroCluster shared-switches configurations.
- Added procedures for MetroCluster installation with third-party storage.
- Added support for FAS2240 systems.
|
Data ONTAP 8.1 RC1 |
September 2011 |
- Removed references to ESH2 and LRC modules.
|
Data ONTAP 8.1 GA |
December 2011 |
- Changed title to Data ONTAP High Availability and MetroCluster Configuration Guide for 7-Mode.
- Added MetroCluster support for Cisco switches.
|
Data ONTAP 8.1.1 RC1 |
May 2012 |
- Added support for automatic giveback after takeover-on-panic.
|
Data ONTAP 8.1.2 RC1 |
October 2012 |
- Added support for 3220 and 3250 systems.
|
Data ONTAP 8.1.2 GA |
November 2012 |
- Added support for the cf.mode option.
- Added coverage for the MetroCluster configuration requirement for both the cf.mode and cf.remote_syncmirror.enable options.
- Added support for native disks in addition to LUNs on storage arrays for V-Series MetroCluster configurations.
|
Data ONTAP 8.2 RC1 |
April 2013 |
- Added coverage for disk pool assignment in a stretch MetroCluster configuration.
|
Data ONTAP 8.2 GA |
May 2013 |