Index  |  Top  -  Up Data ONTAP 8.3

vserver services name-service netgroup load

Load netgroup definitions from a URI

Availability: This command is available to cluster and Vserver administrators at the admin privilege level.

Description

The vserver services name-service netgroup load command loads netgroup definitions from a uniform resource identifier (URI) to a specified Vserver. You can load from a netgroup file at an FTP or a HTTP location (source URI) using the respective protocol.

Before Data ONTAP saves the new netgroup definitions, it checks that the netgroup file does not have any file structure issues, does not contain any syntax errors, and all entries comply with the following rules:

If the file is found to contain errors, Data ONTAP will issue a warning to that effect, but netgroup definitions will nevertheless be loaded into the specified Vserver.

Parameters

-vserver <vserver name> - Vserver

This parameter specifies the Vserver for which you want to load netgroup definitions.

-source {(ftp|http)://(hostname|IPv4 Address|'['IPv6 Address']')...} - URI to load from

This parameter specifies the source URI from which you want to load netgroup definitions. You can load from a URI either using the FTP or the HTTP protocol.

Examples

The following example loads netgroup definitions into a Vserver named vs1 from the file netgroup1 at FTP location ftp://ftp.example.com.
cluster1::> vserver services name-service netgroup load -vserver vs1 -source ftp://ftp.example.com/netgroup1

Index  |  Top  -  Up Data ONTAP 8.3

Copyright © 1994-2015 NetApp, Inc. Legal Information