Table of ContentsView in Frames

Installing Antivirus Connector

You must install the Antivirus Connector to enable the antivirus software to communicate with one or more Storage Virtual Machines (SVMs).

Before you begin

Steps

  1. Start the Antivirus Connector installation wizard by running the appropriate setup file.
  2. Click Next.
  3. In the Destination Folder dialog box, perform one of the following operations:
    • Click Next to install the Antivirus Connector to the folder that is listed.
    • Click Change to install to a different folder.
  4. In the ONTAP AV Connector Windows Service Credentials dialog box, perform one of the following operations:
    • Enter your Windows service credentials.
    • Click Add to select a user.
    This user must be a valid domain user and must exist in the SVMs scanner pool to configure virus scanning.
  5. Click Next.
  6. In the Ready to Install the Program dialog box, click Install to begin the installation.
    A status box opens and shows the progress of the installation, and then the InstallShield Wizard Completed dialog box opens.
  7. Select the Configure ONTAP Management LIFs check box if you want to continue with the configuration of the Data ONTAP management LIFs.
    Note: You must configure at least one Data ONTAP management LIF before the Vscan server can be used.
  8. Select the Show the Windows Installer log check box if you want to view the installation logs.
  9. Click Finish to end the installation and to close the InstallShield wizard.
    The "Configure ONTAP Management LIFs for Polling" icon is saved on the desktop to configure the Data ONTAP management LIFs.