Manual Pages

Table of Contents

NAME

na_rlm - Commands for use with a Remote LAN Module (RLM)

SYNOPSIS

rlm help

rlm reboot

rlm setup

rlm status

rlm test autosupport

rlm test snmp

rlm update

rlm update-status

DESCRIPTION

The rlm command is used with a Remote LAN Module (RLM), if one is present. Using this command, you may get the status of an RLM and test an RLM. Configuration of an RLM can be performed by using the setup command.

OPTIONS

help
Displays a list of Remote LAN Module (RLM) commands.

reboot
Causes the RLM to reboot. If your console connection is through the RLM it will be dropped. The reboot command forces a Remote LAN Module (RLM) to reset itself and perform a self-test.

setup
Interactively configures a Remote LAN Module (RLM).

status
Displays the current status of a Remote LAN Module (RLM).

test autosupport
Performs autosupport test on the Remote LAN Module (RLM). The autosupport test forces a Remote LAN Module (RLM) to send a test autosupport to all email addresses in the option list autosupport.to.

test snmp
Performs snmp test on the Remote LAN Module (RLM). The snmp test forces a Remote LAN Module (RLM) to send a test snmp trap to all traphosts set in snmp command snmp traphost.

update
The RLM firmware is updated. This may be a time consuming operation. Before issuing this command, you need to execute the `software install' command to get the new firmware image. The RLM will be rebooted at the end of this operation.

update-status
Displays the status of an RLM update. The information includes whether an RLM update is currently in progress, the completion percentage, and the start and end time for the update.

HA CONSIDERATIONS

This command only acts upon a Remote LAN Module (RLM) that is local to the system.

EXAMPLES

rlm status

might produce: 

          Remote LAN Module           Status: Online
                         Part Number:        110-00030
                         Revision:           32
                         Serial Number:      296167
                         Firmware Version:   RLM_package_version=1.2.0
                         Mgmt MAC Address:   00:A0:98:01:98:D0
                         Using DHCP:         no
                         IP Address:         172.22.136.61
                         Netmask:            255.255.224.0
                         Gateway:            172.22.128.1

SEE ALSO

na_setup(1), na_options(1)

NOTES

Some of these commands might pause before completing while the Remote LAN
Module (RLM) is queried. This is normal behavior.

Table of Contents

©2016 NetApp Contact Us How to Buy Feedback Careers Legal Privacy Policy Subscriptions (RSS)|