Table of ContentsView in Frames

Configuring Port-based SAN routing policies for Brocade SAN switches

You can configure the port-based SAN routing policies to perform all the SnapMirror features over Fibre Channel in a SAN environment. The out-of-order delivery (OOD) functionality is not supported with port-based SAN routing policies.

Steps

  1. Set the port-based routing policy for all the switches and directors in SAN fabric by using the following command: aptpolicy 1
  2. Enable IODset for all the switches and directors in SAN fabric by using the following command: Iodset
  3. Disable dls for all the switches and directors in SAN fabric by using the following command: dlsreset