Table of ContentsView in Frames

Aborting secondary-to-primary storage transfers

The snapvault abort command can halt ongoing SnapVault transfers from secondary to primary storage that were invoked by the snapvault restore command.

Step

  1. To abort a secondary to primary storage transfer, at the console of either the primary or secondary storage system, enter the following command: snapvault abort [prim_system:]/vol/volx/prim_qtree

    prim_system is the name of the primary storage system.

    prim_qtree is the name of the primary qtree to which the data is being restored.

    Note: If you use the -h option (hard abort) with the snapvault abort command, you cannot restart the transfer.