Table of ContentsView in Frames

Checking qtree SnapMirror transfers in vFiler units

The qtree SnapMirror status displays all the qtree SnapMirror relationships and configurations of a volume in a vFiler unit. You can use the snapmirror status command to check the status of the active transfers in the default vFiler unit and the nondefault vFiler unit.

About this task

In the default vFiler unit, the snapmirror status command displays all the relationships (active and idle) configured in the default vFiler unit and only the active transfer of all other vFiler units in the volume. In the nondefault vFiler unit, the snapmirror status command displays all the relationships (active and idle) of its own volume.

Step

  1. Enter the following command to check the status of active transfers: vfiler run * snapmirror status