Table of ContentsView in Frames

Moving Qtree SnapMirror configurations across vFiler units

You can move all the configurations and relationships of the volume from one vFiler unit to another vFiler unit.

Before you begin

You must remove all the SnapMirror related entries and schedules of the volume from the snapmirror.conf file of the vFiler unit.

Step

  1. Enter the following command on the vFiler unit source: vfiler move source_vfiler destination_vfiler [-f] [-i ip_address] [-i ip_address]...] [path [path...]]
    The following qtree SnapMirror configurations can move from one vFiler unit to another vFiler unit:
    • Softlocks
    • Checkpoint
    • Status