Table of ContentsView in Frames

Checking the initialization of a qtree

You can check the creation and initialization of a destination qtree by using the qtree command.


  1. Enter the following command:qtree
    Note: If you specify no options or arguments, the qtree command displays the status of all the qtrees in the system.
    systemA> qtree
    Volume        Tree  Style  Oplocks   Status
    --------      ----- -----  -------   ------
    vol0                unix   enabled   normal
    qtree24             unix   enabled   normal
    systemB_vol0        unix   disabled  normal
    systemB_vol0  qt1   mixed  enabled   snapmirrored
    systemB_vol0  qt2   unix   disabled  normal
    systemB_vol0  qt3   ntfs   enabled   snapmirrored