Table of ContentsView in Frames

How to check the initialization of a volume

To check that a destination volume has been initialized, you can use the snapmirror status command.

If you specify no options or arguments, the snapmirror status command displays the status of the volumes in the system, as shown in the following example. You also can use the vol status or the qtree command to check whether the volume or qtree is a SnapMirror destination.

systemA> snapmirror status
Snapmirror is on.
Source         Destination       State          Lag       Status
systemA:vol0   systemA:vol0bak   Snapmirrored   00:56:58  Idle
systemA:vol1   systemB:vol6      Source         23:69:26  Transferring (126 MB done)