Table of ContentsView in Frames

Viewing diagnostic results

You can use the netdiag -s command to view a summary of the various diagnostic checks and tests performed on your storage system.

About this task

If you enable the IPv6 option, you can view the IPv4 and IPv6 statistics in the network layer diagnostic summary.

Step

  1. Enter the following command: netdiag -s

Example

The following output shows some issues in IPv6 configuration of the network layer:
netdiag -s
 
Physical Layer Diagnostics Summary:
 
Interface  H/W   Link  Configured   Speed     Duplex     AutoNeg
          Status           UP      Mismatch  Mismatch   Mismatch
e0a          OK   -        N          -         -          -
e0b          OK   -        N          -         -          -
e0c          OK   Y        Y          N         -          -
e0d          OK   -        N          -         -          -
 
 
Network Layer Diagnostics Summary:
 
Protocol         Status
IP                 OK  
IPv6              Prob 
 
 
Transport Layer Diagnostics Summary:
 
Protocol         Status
TCP                OK  
UDP                OK  
 
Use netdiag without the -s option for details