Table of ContentsView in Frames

Configuring Kerberos v5 security services for NFS to use an Active-Directory-based KDC after configuring CIFS

If you have already run cifs setup and configured Data ONTAP to use Active Directory for CIFS, nfs setup automatically uses some of the configuration information you specified for CIFS.

About this task

Note: If you have already used nfs setup to enter configuration information, the prompts you receive might differ from those shown in the following procedure.

Steps

  1. Enter the following command: nfs setup

    You receive the following message from nfs setup:

    Enable Kerberos for NFS?
  2. Enter y to continue.

    You are asked to specify the type of KDC:

    The filer supports these types of Kerberos Key Distribution Centers (KDCs):
    1 - UNIX KDC
    2 - Microsoft Active Directory KDC
    Enter the type of your KDC (1-2):
  3. Enter 2.

    You receive the following message:

    Kerberos now enabled for NFS.
    NFS setup complete.

Result

Data ONTAP is now configured for Active Directory-based KDC Kerberos over NFS.