Table of ContentsView in Frames

Reasons storage arrays are missing from command output

A storage array that is not connected to the Data ONTAP system does not appear in the storage array config show output. Problems with cabling, zoning, and host group configuration can prevent a connection between the two devices.

Resolving the issue

  1. Check cabling, host group configuration, and zoning as follows:
    • Check that cables are connected.
    • Check that the WWPNs for the FC initiators on the Data ONTAP systems are in the host group.
    • Check that both the storage array and the FC initiator are in the same zone.
  2. After the problem is fixed, run storage array config show in Data ONTAP to confirm that the issue was fixed.