Table of ContentsView in Frames

Stopping the volume clone or LUN clone split operation

You can stop the clone split for a volume clone or LUN clone using the job ID or file specification.

Step

  1. Enter the following command:
    snapdrive clone split stop [-lun] long_lun_name [long_lun_name...] |[{-dg | -vg | -fs | -hostvol | -lvol} file_spec [file_spec...]] | [-job <jobid>]

    SnapDrive for UNIX stops the clone split stop operation that is in progress.

Example

The following example shows the clone split operation that is stopped by using the file specification.
# snapdrive clone split stop -fs /mnt/my_mnt4 /mnt/my_mnt3
Clone-Split for "/mnt/my_mnt4" is 0% Completed and Stopped.
Clone-Split for "/mnt/my_mnt3" is 0% Completed and Stopped.
The following example shows the clone split operation that is stopped by using the job ID.
# snapdrive clone split stop -job B265Dbv8gh
Clone-Split for "/mnt/my_mnt3" is 14% Completed and Stopped.
Clone-Split for "/mnt/my_mnt4" is 17% Completed and Stopped.

The following example is a typical output that shows the clone split stop operation for a file specification that is already stopped.

# snapdrive clone split stop -fs /mnt/my_mnt4 /mnt/my_mnt3
Clone-Split for "/mnt/my_mnt3" is not stopped : No split is in progress for this resource
Clone-Split for "/mnt/my_mnt4" is not stopped : No split is in progress for this resource
Note:
  • If the clone split is stopped for a particular file specification in the job id and the clone split stop is successful, then file specification is removed from the job.

  • If the clone split is stopped for a job, and the clone split stop is successful for all the file specification in the job, the job is removed from the job set.