Table of ContentsView in Frames

Resetting the snap reserve option by using FilerView

When you use Data ONTAP in an FC or iSCSI environment, you should reset the snap reserve option to 0 percent by using FilerView.

Steps

  1. Open a FilerView session to the storage system holding the volume whose snap reserve setting is to be changed.
  2. From the main FilerView, navigate to Volumes > Snapshot > Configure.
  3. In the Volume field, select the volume whose snap reserve setting is to be changed.
  4. In the Snapshot Reserve field, enter 0.
  5. Click Apply.