Table of ContentsView in Frames

Verifying the supported configurations

You can verify the supported configurations in SnapDrive for UNIX depending on the value specified for each component in the snapdrive.conf file.

Step

  1. Enter the following command: sdconfcheck check

Example

The following example shows the output:
#/opt/NetApp/snapdrive/bin/sdconfcheck check
				
Detected PowerPC Architecture
Detected IBM AIX OS
Detected Kernel Version 5.3.0.0
Detected Volume Manager Version 5.3.12.3
Detected VIO Client Partition
Detected Host OS   AIX5.3 TL12 SP4
Detected NFSv3 FileSystem on AIX
Detected FCP on AIX
Detected Software iSCSI on AIX
Detected NFSv4 Filesystem on AIX
Detected   AIX JFS File System
Detected   AIX JFS2 File System
Detected   AIX Native LVM
Detected   AIX Native MPIO

Did not find any supported cluster solutions.
Detected   FCP AIX Host Utilities 5.1
Detected   iSCSI AIX Host Utilities 5.1

Supported Configurations on this host by SDU Version 5.2
-------------------------------------------------------------
AIX NFS Configuration
AIX FCP JFS/JFS2 on LVM without Multipathing and Clustering Solution
AIX FCP JFS/JFS2 on Raw Lun without Multipathing and Clustering Solution
AIX Software iSCSI JFS/JFS2 on LVM without Multipathing and Clustering Solution
AIX Software iSCSI JFS/JFS2 on Raw Lun without Multipathing and Clustering Solution
AIX FCP JFS/JFS2 on LVM with NativeMPIO multipathing Solution
AIX FCP JFS/JFS2 on Raw Lun with NativeMPIO multipathing Solution
AIX Software iSCSI JFS/JFS2 on LVM with NativeMPIO Multipathing Solution
AIX Software iSCSI JFS/JFS2 on Raw Lun with NativeMPIO Multipathing Solution