You must specify the user login information for the Vserver. Depending on what you specified when you set up the Vserver, each Vserver must use the configured Vserver user name. If there is a change in your Vserver name, you must ensure that the new Vserver name is configured in SnapDrive for UNIX.
- Enter the following command: snapdrive config set user_name filername [filername ...]
- user_name is the
user name that was specified for the Vserver when you first set it
up. The default user is vsadmin. filername is the Vserver name.
- filer_name allows you to enter multiple Vservers on one command
line if they all have the same user login or password. You must
enter at least one Vserver name.
# snapdrive config set vsadmin clstr-vs2
Password for vsadmin: