Table of ContentsView in Frames

Commands for monitoring data loss events

If you enable the NVFAIL option, you receive notification when a system crash caused by NVRAM inconsistencies or a MetroCluster switchover occurs.

By default, the NVFAIL parameter is not enabled.
If you want to... Use this command...
Create a new volume with NVFAIL enabled volume create -nvfail on
Enable NVFAIL on an existing volume volume modify
Note: You set the -nvfail option to on to enable NVFAIL on the created volume.
Display whether NVFAIL is currently enabled for a specified volume volume show
Note: You set the -fields parameter to nvfail to display the NVFAIL attribute for a specified volume.

See the man page for each command for more information.