When planning your MetroCluster configuration for use with disks and array LUNs, you must consider various factors, such as the order of setting up access to storage, root aggregate location, and the usage of FC initiator ports, switches, and FC-to-SAS bridges.
Consider the information in the following table when planning your configuration:
Consideration | Guideline |
---|---|
Order of setting up access to the storage | You can set up access to either type of storage (disks or array LUNs) first. You must complete all setup for that type of storage and verify that it is set up correctly before setting up the other type of storage. |
Location of the root aggregate |
|
Using switches and FC-to-SAS bridges | FC-to-SAS bridges are required to connect the Data ONTAP systems with the disk shelves through the switches. You must use the same switches to connect to the storage arrays and the FC-to-SAS bridges. |
Using FC initiator ports | The FC initiator ports used to connect to an FC-to-SAS bridge must be different from the initiator ports used to connect to the switches, which connect to the storage arrays. A minimum of eight FC initiator ports is required to connect a Data ONTAP system to both disks and array LUNs. |