Verifying the HA state of components is mcc in Maintenance mode

In a MetroCluster configuration, the HA state of the controller and chassis components must be set to mcc so they boot up properly. For systems received from the factory, this value is pre-configured and you do not need to verify it.

Before you begin

The system must be in Maintenance mode.

About this task

This task is not required on systems received from the factory.

This task must be performed on each node.

Steps

In Maintenance mode, display the HA state of the controller module and chassis: ha-config show
The HA state should be mcc for all components.
If the displayed system state of the controller is not mcc, set the HA state for the controller module to mcc: ha-config modify controller mcc
If the displayed system state of the chassis is not mcc, set the HA state for the chassis to mcc: ha-config modify chassis mcc
Boot the node to Data ONTAP:boot_ontap
Repeat these steps on each node in the MetroCluster configuration.