Table of ContentsView in Frames

How you can use disks with mixed speeds in the same aggregate

Whenever possible, you should use disks of the same speed in an aggregate. However, if needed, you can configure Data ONTAP to allow mixed speed aggregates based on the disk class.

To configure Data ONTAP to allow mixed speed aggregates, you use the following RAID options:

When these options are set to on, Data ONTAP allows mixing speeds for the designated disk class. Performance disk types are FC and SAS; capacity disk types are BSAS, FSAS, MSATA, and ATA.

By default, raid.mix.hdd.rpm.performance is set to off, and raid.mix.hdd.rpm.capacity is set to on.

Even if Data ONTAP is not configured to allow mixing speeds, you can still create aggregates out of disks with different speeds by setting the -allow-mixed parameter to true.