Table of ContentsView in Frames

Changing the checksum type of an array LUN

You must change the checksum type of an array LUN if you want to add it to an aggregate that has a different checksum type than the checksum type of the LUN.

Before you begin

You must have reviewed the tradeoffs between performance in certain types of workloads and storage capacity utilization of each checksum type. The FlexArray Virtualization Installation Requirements and Reference Guide contains information about checksum use for array LUNs.

You can also contact your Sales Engineer for details about using checksums.

About this task

Step

  1. Enter the following command to change the checksum type: storage disk assign -disk disk name -owner owner -c new_checksum_type
    disk name is the array LUN whose checksum type you want to change.

    owner is the node to which the array LUN is assigned.

    new_checksum_type can be block or zoned.

    Example
    storage disk assign -disk EMC-1.1 -owner system147b -c block
    The checksum type of the array LUN is changed to the new checksum type you specified.