Table of ContentsView in Frames

Resuming an SVM peer relationship

A cluster administrator can resume a suspended SVM peer relationship by using the vserver peer resume command. For example, after the maintenance is complete, you can resume the suspended SVM peering relationship.

About this task

Any SnapMirror data transfer that was scheduled to run during the suspension period will not get initiated when you resume the SVM peer relationship. You must manually initiate the data transfer.

Steps

  1. Use the vserver peer resume command to resume a suspended SVM peer relationship from either of the peered clusters.
    Example
    The following example shows how to resume a suspended SVM peer relationship:
    cluster1::> vserver peer resume -vserver vs4.example1.com -peer-vserver vs0.example1.com
                 
    Info: [Job 76] 'vserver peer resume' job queued
    The SVM peer relationship is in peered state.
  2. Use the vserver peer show command to verify the status of the SVM peer relationship.
    Example
    The following example shows how to verify the status of the SVM peer relationship:
    cluster1::> vserver peer show
    
                      Peer              Peer
    Vserver           Vserver           State
    -----------       -----------       ---------
    vs4.example1.com  vs0.example1.com   peered
    
    
    For more information about these commands, see the man pages.