Table of ContentsView in Frames

(Native multipathing) Using sanlun to display DM-Multipath information

When you are using DM-Multipath, you can use the sanlun command to confirm that DM-Multipath is set up.


  1. Enter the following command on the Linux host console: sanlun lun show -p
    You can also use the sanlun lun show all command to display more information about your LUN setup, such as whether you are using LUNs mapped with clustered Data ONTAP or Data ONTAP operating in 7-Mode.
    Note: Check the Interoperability Matrix to determine if clustered Data ONTAP is supported with your Host Utilities environment.