When you use the sanlun command to display multipathing information for VxDMP, the command output varies depending on the protocol you are using.
The following sections provide examples of the type of output produced when you run the sanlun command in the following VxDMP environments:
In the following example, the sanlun lun show -p command is issued in a Host Utilities environment that is running the FC protocol with Veritas Storage Foundation and Data ONTAP operating in 7-Mode. The output from the command shows that VxDMP is configured.
# sanlun lun show -p ONTAP Path: fas6030-201-71:/vol/vol1/lun1 LUN: 12 LUN Size: 7g Controller_CF_State: Cluster Enabled Controller Partner: fas6030-201-70 Mode: 7 DMP NODE: fas60300_9 Multipath Provider: Veritas --------- ---------- ------- ------------ ---------------------------------------------- host controller controller path path /dev/ host target state type node adapter port --------- ---------- ------- ------------ ---------------------------------------------- up secondary sdn host3 2a up primary sdbg host3 2a up primary sdes host4 2b up secondary sdcz host4 2b
In the following example, the sanlun lun show -p command is issued in a Host Utilities environment that is running the iSCSI protocol with a software initiator Veritas Storage Foundation and Data ONTAP operating in 7-Mode. The output from the command shows that VxDMP is configured.
# sanlun lun show -p ONTAP Path: fas6030-201-70:/vol/vol1/lun1 LUN: 21 LUN Size: 7g Controller_CF_State: Cluster Enabled Controller Partner: fas6030-201-71 Mode: 7 DMP NODE: fas60300_44 Multipath Provider: Veritas --------- ---------- ------- ------------ ---------------------------------------------- host controller controller path path /dev/ host target state type node adapter port --------- ---------- ------- ------------ ---------------------------------------------- up iscsi sdaq host6 10.72.201.24 up iscsi sdbp host7 10.72.201.25